| Internet-Draft | Secure IP Binding Synchronization via BG | July 2022 |
| Dikshit & Gadekal | Expires 2 January 2023 | [Page] |
The distribution of clients of L2 domain across extended, networks leveraging overlay fabric, needs to deal with synchronizing the Client Binding Database. The 'Client IP Binding' indicates the IP, MAC and VLAN details of the clients that are learnt by security protocols. Since learning 'Client IP Binding database' is last mile solution, this information stays local to the end point switch, to which clients are connected. When networks are extended across geographies, that is, both layer2 and layer3, the 'Client IP Binding Database' in end point of switches of remote fabrics should be in sync. This literature intends to align the synchronization of 'Client IP Binding Database" through an extension to BGP control plane constructs and as BGP is a typical control plane protocol configured to communicate across network boundries.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 2 January 2023.¶
Copyright (c) 2022 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
BGP: Border Gateway Protocol¶
VTEP: Virtual Tunnel End Point or Vxlan Tunnel End Point¶
RD: Route Distinguisher¶
RT: Route Target¶
NLRI: Network Layer Reachability Information¶
EVPN: Etherenet Virtual Private Network¶
The distribution of clients of L2 domain across extended, networks leveraging overlay fabric, needs to deal with synchronizing the Client Binding Database. The 'Client IP Binding' indicates the IP, MAC and VLAN details of the clients that are learnt by security protocols. Since learning 'Client IP Binding database' is last mile solution, this information stays local to the end point switch, to which clients are connected. When networks are extended across geographies, that is, both layer2 and layer3, the 'Client IP Binding Database' in end point of switches of remote fabrics should be in sync. This literature intends to align the synchronization of 'Client IP Binding Database" through an extension to BGP control plane constructs and as BGP is a typical control plane protocol configured to communicate across network boundries.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].¶
When used in lowercase, these words convey their typical use in common language, and they are not to be interpreted as described in [RFC2119].¶
Access Switches, build trusted database of L3 clients by snooping into DHCP/ND packets in the client VLAN. This database can be leveraged by security and analytical features. Security features help in protecting the network from unauthorized/untrusted users while analytical features/application gauge the nature of access with the telemetry information for the designated hosts. This information help keeping the network health in a secure and informed way¶
In Campus networks of Colleges, Branch office, Headquarters and DataCenter DC networks, it is a very common deployment, for networks, to extend Layer-2 across sites and geographies over WAN, Wide Area Network, via well defined overlay fabric solution like EVPN and constructs like Vxlan, GPE, GUE, NVGRE, with Vxlan being the most deployed. The solution for Campus and DC can be combined for enterprise solutions as well.¶
The campus networks are extended between headquarter and branch offices where as DCs are extended for load sharing, resiliency, hierarchical availability of data across geographies and region. In such deployments, the client database ends up being local to the first-hop access switch or gateway, the client is connected to. Client connected to the first hop access switch or gateway. The other set of access switches within or remotely placed in the extended fabric, treat the client as untruste or unauthorized on the client VLAN. This would result in switches to deny services to legitimate clients.¶
The following diagram shows the topology of disparate fabrics.¶
|(--------------FABRIC1 ----------------)|(--WAN------)|(----------FABRIC3---------------)|
+---------+ ________+-------+ +------+ +-----+
+----+ | +-------+ | |Border3|--|VTEP31|-[Vlan20]-|host3|
|host1|-[vlan10]-|VTEP11 |--+ | +-------+ +------+ +-----+
+----+ | +-------+ | +-------+ | FABRIC-3
| |----|Border1|----| WAN ===================================
| FABRIC-1 | +-------+ | FABRIC-2
+----+ | +------+ | | +-------+ +------+ +----------+
|host2|- [vlan20]-|VTEP12|--+ |________|Border2|--|VTEP21|-[Vlan10]-|Wireless |--Clients1..n
+----+ +------+ +-------+ +------+ |Controller|
|(--------------FABRIC1 ----------------)|(--WAN-----)|(------------------FABRIC2----------------------------)|
In the above mentioned topology diagram,¶
For example, to protect from neighbor cache depletion attacks, a switch can be configured to perform resolution only for the known clients in the network. This is not possible if Client IP Binding Database is not synced. NOTE, the above diagram, leverages BGP EVPN provisioned overlays over Vxlan fabric as the network extension instrument. Though the example can be generalized for any BGP provisioned overlay network like VPLS, VPWS, L3VPN etc.¶
One possible option is to build the client database by sniffing into data plane packets. This class of solution is ingrained with problems.¶
This solution requires learnings over broadcast packets like ND and ARP. The bridge-domain extension over fabrics, will require the broadcasts to travel over the WAN pipe, and needs to be refreshed periodically as and when there is a request for host discovery. With reference to the above diagram, Gratuitous ARP(GARP), generated by Host2, will be required to be flooded to remote fabrics (fabric 2 and 3), in a typical data plane learning. But with EVPN control plane and arp-suppression techniques, there is minimal leak of arp broadcasts in the EVPN fabric, and thus the WAN. Hosts attached to access switches may GARP frequently (too many and too often), thus aggravating the broadcast leaks over WAN. As mentioned in the topology description, DCHP Snooping will not help here, as DHCP packets will not make it to remote fabrics. Even in DCHP Relay based deployments, the Relay configuration is local to a fabric and cannot be leaked to remote fabrics.¶
There is a possibility that same subnet allocation for ip address happens across disparate Vlans within or across the fabrics. Vlan 10 in fabric1 and Vlan20 in fabric 2 are mapped to same subnet gateway, lets say, 10.0.0.0/24. The IP binding database learnt via DHCP or ND snooping (hosted on access Vtep11 and Vtep13) needs to be synchronized as the broadcast domain is extended over a different VNI, lets say, 100 and 200 (mapped to vlan 10 and 20 respectively). Thus the problem at hand is that the allocations (IP bindings) are to be synchronized for same or different subnet, but across the Vlans in disparate fabrics. This is not possible with following deployment¶
Note that, In BGP Control plane, Route Targets help go around this anomaly with dataplane learnings.¶
With dataplane solution (via GARP or ND), the flooding over WAN to all remote fabrics will lead to unwarranted learning in fabrics over which there is no operator control.¶
In cases where DHCP Relay is configured,¶
For example, in above diagram, the host1 GARP is flooded over WAN to both fabric2 and fabric3, even though the intention, is to sync the information to fabric2 only.¶
If a wireless client, lets say, host1, moves in a lift or elevator across floors and hence across gateways, the security policy synchronization is a must between the Vteps sitting behind the wireless controllers. Rather than waiting for client to speak up behind every wireless controller, the first controller and corresponding vtep can publish the security clearance or security risk of the host to all remote vteps.¶
This document proposes a solution for synchronizing the IP Bindings between the Access Switches by leveraging the BGP EVPN control plane constructs called Route Type 2 NLRIs (EVPN NLRI, MAC Advertisement Route). The proposal defines a new extended community, which indicates the IP Binding synchronization, to be carried, in BGP Update message carrying the Route Type 2 NLRI (Network Layer Reachability Information). As EVPN is the at the core of fabric deployments to support multihoming and multitenancy, this control plane extension alleviates the Synchronization of IPs which is specific to tenants and applicable to all or selective hosts attached to the Access Vteps. The host can be attached to more than one Vtep (indicating multihoming) over a segment (called Ethernet Segment). BGP EVPN is a goto solution for Vxlan fabric extension across the WAN, as its also easy to realize the native transport (underlay) encapsulation as IP based.¶
For example, in the above diagram Vtep11 (also hosting the IP Binding database), publishes BGP update messages, carrying EVPN Route Type 2 for all the local MAC,IP learnings to the remote BGP peers (within or across the fabrics). These MAC,IP learnings are typically learnt via local dynamic learnings that is, host1 sends a GARP towards Vtep11 and is received on Vtep11 over the client (tenant) facing gateway interface (interface vlan 10). This interface can be a Vlan interface mapped to the subnet, for example, interface vlan 10 on Vtep11. All hosts attached over vlan 10 to Vtep11 are allocated the same subnet IP address and monitored by the IP Binding (or security validation) application hosted on Vtep11. Note that the similar validation is performed on all the access switches in a secure network. The dynamic learnings are validated against the IP Binding database (learnt via typically) as indicated in the EVPN Route Type 2. Note that the process of learning the IP Bindings (via snooping of DHCP or ARP) is outside the purview of this document.¶
A new extended community Path attribute called Client-IP Binding Sync Extended Communities is defined. This attribute is an optional attribute and also transitive in nature and can be relayed in the control plane path. This attribute, if carried along with BGP update message with MAC, IP bindings (with EVPN NLRI, MAC Advertisement Route), indicates the following to the receiving BGP peer¶
The following diagram shows the Client IP Binding Sync Extended Communities¶
0 1 2 3 4
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |0| Type | Sub-Type | Client IP Binding Sync ID |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Client IP Binding Sync ID (cont.) |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Field | Description
============================================================
Type | 1 Octet size, Type field can be newly defined as a proprietary one.
| Its a transitive Attribute, hence 1 bit in this octet is 0.
|
Sub-Type | 1 Octet size. The value of sub-type will be allocated as per IANA
| For experimental purposes, it can be used as any unallocated value
| within the free range.
| This field when set to appropriate value indicates to the receiver
| about processing the NLRI for IP-Binding synchronization.
|
Client IP Binding | 6 Octets size, This field carries the Identifier configured
Sync ID |to categorize the IP Binding instance.
| The field is applicable to all data carried in MAC IP NLRIs in the same update message.
| The instance is configurable and value is implementation dependent.
the following section gives a detailed flow of the send and receive side processing the new PDU.¶
The following set of bullets describe the 'Send Side Processing' flow¶
the following bullets describe the 'Receive Side Processing'¶
If the receiving BGP peer SUPPORTs the Client IP Binding Sync Extended Communities in the received Route Type 2, It decodes the Extended Communities and extracts the "Client IP SYNC ID" value. It matches the value with the locally configured one.¶
The augmented control plane feature, helps all Access swtiches to be synchronized with respect to allowed or validated client credentials, thus preventing rogue traffic or DoS attacks 'originating in' or 'destined to' the local network.¶
Backward Compatibility for non-support nodes is as per the following standards already defined in [RFC7606], that, BGP speaker should discard the unsupported TLV types¶